登录    注册    忘记密码

详细信息

Introduction and analysis of shaping design of parts and some typical shaping method    

文献类型:期刊文献

中文题名:Introduction and analysis of shaping design of parts and some typical shaping method

英文题名:Introduction and analysis of shaping design of parts and some typical shaping method

作者:Yang Guanghui[1];Chen Hua[1];Liu Ziping[2];Li Lixin[2]

第一作者:Yang Guanghui

机构:[1]School of Mechanical Engineering,University of Science and Technology Beijing;[2]School of Mechanical and Electronic Engineering,Beijing Union University

第一机构:School of Mechanical Engineering,University of Science and Technology Beijing

年份:2016

卷号:26

期号:3

起止页码:53-60

中文期刊名:计算机辅助绘图设计与制造:英文版

基金:Supported by 2015 Undergraduate Education and Teaching Reform and Research Project of University of Science and Technology Beijing(JG2015M15);2014 Education and Teaching Reform and Research Project of University of Science and Technology Beijing(JG2014M22)

语种:英文

中文关键词:成形方法;成形设计;零件;造型设计;设计能力;机械制图;设计过程;设计方法

外文关键词:shaping method; mechanical drawing; spatial imagination

摘要:In order to improve the shaping design ability of students in mechanical drawing,it is necessary to introduce and analyze the shaping design of parts and some typical shaping method.Firstly,shaping designs of different structures of some parts such as installation part,connection part and so on are introduced,and then the shaping design procedure of the base of reducer is analyzed.Secondly,some typical shaping design methods such as shaping design based on the deformation of the basic body,profile design shaping design,complementary shaping design,equal volume shaping design,variation shaping design and combinatorial shaping design are introduced and analyzed.Finally,the design model of various pipe joints used in the exhibition hall is given as a design question.It will be helpful to improve the spatial imagination and shaping ability of students.
In order to improve the shaping design ability of students in mechanical drawing, it is necessary to introduce and analyze the shaping design of parts and some typical shaping method. Firstly, shaping designs of different structures of some parts such as installation part, connection part and so on are introduced, and then the shaping design procedure of the base of reducer is analyzed. Secondly, some typical shaping design methods such as shaping design based on the deformation of the basic body, profile design shaping design, complementary shaping design, equal volume shaping design, variation shaping design and combinatorial shaping design are introduced and analyzed. Finally, the design model of various pipe joints used in the exhibition hall is given as a design question. It will be helpful to improve the spatial imagination and shaping ability of students.

参考文献:

正在载入数据...

版权所有©北京联合大学 重庆维普资讯有限公司 渝B2-20050021-8 
渝公网安备 50019002500408号 违法和不良信息举报中心